SanSiro VTASL73 73" Heated Air Jetted Single Slipper Tub with Drain and Ozone Sanitizing
Ready to plug in to a 15 amp 110 v GFCI
Includes a Victoriana drain and overflow in choice of finishes to match your fittingsDrain finish options are chrome, brushed nickel, oil rubbed bronze, polished nickel, matte black and brushed brassIncludes 12 air injectors finished in white in the tub floorFor additional hygiene, each air injector is fitted with a check to prevent water entering the air linesThe air blower and all fittings are concealed within the tub shellsDesigned and manufactured for optimal strength and water heat retentionRequires ONE 110v - 15 amp GFCI electrical connectionElectrical can be placed under the tub with a remote GFCI access or connected to a wall mount GFCI outside the tub
SanSiro Jetted Tubs - Electrical Cord Position on Tub
All of the jetted tubs in the SanSiro range use a 3' long cable 110v – 15-amp standard 3 pin plug. You have choices as to where you would like the plug on the jetting system to connect to the GFCI outlet in your home.
1 - Leave the connection under the tub. In this case, you would need to have your GFCI at the control board and not on the plug under the tub.
2.- Connect to a wall socket GFCI. You can drill holes in the outside of the tub and run the electrical cable to a wall mounted GFCI near the tub.
3 - To drill the holes, we recommend first drilling a 1/8” pilot hole and then using a 1.25” hole saw. The acrylic can chip if you use a blunt hole saw. If you have two plugs, drill two holes.
4 - You can then feed the cord through the hole(s) and attach the rubber grommet/washer we supply with some super glue or caulk. This grommet fits on the outside of the tub to prevent a rough tub edge rubbing on the electrical cord.
Just in case you need it, we include a 6’ long extension cord for each plug on the tub.