Home > Shop by Size >

“SanSiro VTADS73” 73 Inch Heated Air Jetted Double Slipper Tub with Drain and Concealed Blower
VTADS73 73in Hot Air Massage Double Slipper Tub
 
Alternative Views:
There is a deck area on this tub and it can be used with many deck mounted faucets and all wall mounted and freestanding faucets.
If you purchase a faucet from us, we will drill the deck holes to suit the faucet.
Includes Victorian drain with overflow
Ultra-Quiet heated single speed air blower located inside pedestal base
Powerful 600w heater on the blower to increase air bubble temperature
When the bubbles enter the water, even though they are warm, they will feel slightly cool to the skin
Blower is equipped with two Anti-back flow devices as per UL requirements
Requires a dedicated standard 15amp - 110v GFCI
Blower activator button will be placed on the deck area
20 individual white air injectors in the floor
Three foot of cable from the tub to the wall
Slip resistant floor

MA Code Accepted

Reference

Download Specification Sheet (JPG, 68kB)

Your Price: $2,980.00



Availability:: DISCONTINUED
Product Code: VTADS73


SS Overflow and Drain Finish*:

Suitable Faucet at 45% Discount*:

Ozone Sanitizing*:

Tub Exterior Color*:

Description Electrical Cord
 
VTADS73 73" Heated Air Jetted Double Slipper Tub with Drain and Concealed Blower
Ready to plug in to a 15 amp 110 v GFCI
Photo here shows 67" version of the tub, proportions may change a little on different length tubs

Soothe away the aches of the day in a luxurious heated air massage bathtub. We offer single speed on/off control. All of our individual flat face air injectors are placed on the bottom of the tub to massage calves and thighs. We use a powerful 600w heater in our hot air blower to increase the ambient temperature 15 to 20 degrees within a period of around 2 minutes, so switching the air jetting on before entering the tub can be a good idea.While the air is heated, it can still feel slightly cool when the bubbles meets the skin, it will not feel hotter than the water in the tub.
Installation on this tub is very simple, everything needed is part of the tub. Simply connect the regular 3-pin plug to a 110v-15 amp GFCI and you're ready to go. The blower is inside the pedestal. In the unlikely event of a blower failure, replacing it is also very simple, just disconnect the electric and tub from the drain, turn it over and replace the blower, about a 30 minute job.
To maintain hygiene in the air pipes, every time you take a bath and drain the water, engage the blower for about 15 seconds to purge all residual water in the lines. Every three months, we recommend that you fill the tub about two inches over the highest jet with luke warm water and add a half cup of bleach. Engage the blower and let run for two minutes. Empty and repeat this step with clean water and purge the lines when the tub is empty.